Servo Transponder Mount - Spektrum and Tekno

Available in a variety of configurations for major servo brands, these mounts simply replace the original back of your servo. Once the swap is complete, mount the servo back into your vehicle, and slide the transponder into its new home. Transponder swaps have never been faster, or looked cleaner! No more fuzzy, floppy mess, just quick, snappy transponder changes every time.

Our exclusive Tekno 410 mount does things a little differently. Save your transponder wires from the potential doom of getting wrapped up in the driveshaft or steering bellcranks: our custom part moves the transponder up and out of harms way, right next to your speed controller. Designed to use the stock hardware, this part also incorporates the same antenna holder as found in the stock piece as well, again using the factory hardware.

Note: The tolerances of the transponder mounts can be slightly altered by the user with just a little bit of heat: we recommend using a lighter. Simply hold the tip of the flame 3-4 inches under the mounting tab to soften the plastic slightly, for NO MORE THAN 4 SECONDS. Press in lightly with your finger to achieve the desired "pinch" and hold for a few seconds until the plastic cools in place. Careful!! The plastic will be hot! Once complete, check the tightness of the transponder mounting action by inserting the transponder into the slot. If it is too tight, this process can be repeated in reverse: we recommend using the back end of a pair of tweezers to pull the tab back out away from the body of the servo.